Course: VACUUM SYSTEM DESIGN
|Cert. in Mfg. Leadership - Dutchess|
|Cert. in Mfg. Leadership - Rockland|
|Cert. in Mfg. Leadership - Westchester|
|display all courses|
Attention: This course is not currently being run. If you are interested in this training please contact the Council of Industry or phone us at (845) 565-1355.
This course deals with the principal aspects of system design, including materials selection, fabrication techniques, pump selection, sizing pumps and vacuum piping to a chamber, determining pump down-time, leak rate specification, and surface preparation procedures. Methods for determining ultimate pressures are also discussed.
The course demonstrates that establishing the vacuum environment is the primary criterion for designing, constructing, and operating a vacuum system. A wide range of vacuum environments are discussed, from rough to ultrahigh vacuum, with emphasis on achieving a well-defined degree of vacuum.